Stonegate Supplies
Stonegate Knowledge

Knowledge Hub

Practical guidance for roofing, landscaping, outdoor-living products and trade projects. Expert advice to help you choose the right materials, install with confidence and get the job done.

Roofer rolling a taped joint between new black EPDM and cleaned weathered EPDM
Installation Advice 23 August 2026

How Do You Join New EPDM to an Existing EPDM Roof?

How to assess, clean, prime and tape a new-to-existing EPDM connection—and when wet, contaminated or unsecured roofing should be stripped instead.

Read article →
Roofer inspecting wet EPDM membrane at a gutter-edge trim after rainfall
Installation Advice 23 August 2026

Why Is Water Getting Behind My EPDM Roof Edge Trim?

Diagnose leaking EPDM gutter and kerb trims, from trapped membrane and open corners to poor falls, failed compression and upstream water entry.

Read article →
Roofer checking the fall of a flat roof deck with a long spirit level before laying EPDM
Installation Advice 23 August 2026

Can You Install EPDM on a Flat Roof With No Fall?

UK guidance on minimum completed falls, ponding risks, outlets and practical ways to create or restore drainage before installing EPDM.

Read article →
Roofer rolling uncured EPDM flashing around a round pipe penetration on a flat roof
Installation Advice 23 August 2026

How to Seal EPDM Around Pipes and Roof Penetrations

A practical guide to EPDM pipe boots, uncured flashing, primer, rolling, clamps and penetration repairs—with the mistakes that commonly cause leaks.

Read article →
Roofer rolling uncured EPDM corner flashing around a flat-roof rooflight upstand
Installation Advice 23 August 2026

How to Install EPDM Around a Rooflight or Upstand

Plan and form a reliable EPDM rooflight detail using the correct upstand, contact adhesive, primer, uncured corner flashing and termination.

Read article →
Roofer checking an EPDM membrane and roof-deck temperature before a cold-weather installation
Installation Advice 23 August 2026

Can You Install EPDM in Cold or Damp Weather?

Learn how cold, humidity, dew and damp decking affect EPDM installation—and how to plan adhesives, primer and detailing around a safe weather window.

Read article →
Roofer applying primer and rolling a cover strip over an EPDM roof seam repair
Installation Advice 23 August 2026

How Do You Repair a Leaking or Lifting EPDM Seam?

Learn why EPDM seams lift, how to assess a leak and when to use primer, seam tape, cover tape, flashing or a complete repair kit.

Read article →
Roofer inspecting bubbles and wrinkles in a newly installed EPDM flat roof membrane
Installation Advice 23 August 2026

Bubbles and Wrinkles in an EPDM Roof: Causes and Solutions

Learn what causes bubbles, blisters and wrinkles in EPDM roofing, which defects may settle and when an installation needs closer inspection or repair.

Read article →
Installer fixing composite cladding to a battened garden-room wall
Installation Advice 14 August 2026

Planning Composite Cladding: Boards, Battens and Trims

Measure the net wall area, design a ventilated subframe and resolve every opening and corner before calculating boards. A practical pre-order cladding checklist.

Read article →
Roofer applying water-based EPDM deck adhesive to a clean OSB roof
Installation Advice 14 August 2026

EPDM Adhesives Explained: Which Adhesive Do You Need?

Match EPDM adhesive to the membrane, substrate and roof detail. Learn when to use water-based, contact, spray and PU adhesive — and what not to interchange.

Read article →